Vacuum large debris from your interior before using the Tornador Classic. Pressurize your air tool with an air compressor capable of producing 5.2-5.4CFM @ 90PSI, and at air pressures set between 75-90PSI Max. When cleaning fabrics, turn the liquid air valve to the upright position to release the cleaning product. Hold the nozzle a few inches from the fabric and spray in an overlapping motion. Turn the valve to the down position to dry with air. For cleaning vinyl and plastics, apply the product at 90 PSI. Allow the product to sit on the surface for 10 to 15 seconds. Wipe product off with a link https://www.detailking.com/products/edgeless-creature-towels-16×16 245 Edgeless Microfiber Towel . Use the air gun, following with the towel, to dry crevices and creases. You’ll never want to detail without the Tornador again! Be sure to also check out our more powerful https://www.detailking.com/products/tornador-black-car-cleaning-gun tornador black Tornador Black Instructions for use for cleaning fabric: ordered Remove large debris and vacuum area to be cleaned. Turn liquid air valve to an upright position to deliver a cleaning solution. Hold cleaning nozzle 1 to 3 inches from area to be cleaned. Fully depress trigger, begin overlapping motion over an area to be cleaned. Next turn valve to down position using just air to help dry area that you just cleaned! Instructions for cleaning dashboard and hard vinyl/plastic surfaces: Recommended air pressure at 90 psi. Turn liquid valve to the straight-up vertical position, using an overlapping motion, spray area to be cleaned. Allow cleaning liquid to remain on the surface for 10-to 15 seconds. Follow with air only by turning the valve to the horizontal position, begin drying with overlapping motion followed with a soft towel.